In the process of loading and unloading the hose, pay attention to the following points
During the loading and unloading process of the hose, light loading and unloading should be done.
The hose needs to be sorted in rolls (strips) and shipped neatly. To avoid excessive bending and discounting of the tube body, other heavy objects should not be piled on the hose.
It is strictly forbidden to mix the hose with acids, alkalis, oils, organic solvents, and flammable and explosive materials; the pipe body should not be in direct contact with goods with sharp edges.
For hoses that need to be transported straight, when the length exceeds the loading compartment, the extra-long part should be supported by brackets to prevent the hose from being dragged and damaged on the ground.
If the hose needs to be temporarily parked in the open air (or workshop dock) for some reason, the site must be leveled, the hose should be neatly laid down, and covered under the cover without stacking heavy objects; at the same time, the hose should not be in contact with the heat source.
When carrying the hose, it should not be dragged anywhere. For heavy hoses, lifting equipment or special equipment should be used for loading and unloading, and the hose should be protected from accidental damage.
Send your message to us:
Post time: Sep-04-2020